Zeagle Buoyancy Compensator Owner's Manual Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 22
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
15
Pre-dive Assembly and Inspection
Over Pressure Valve (OPV)
The over pressure / dump valve is typically located on the top left shoul-
der area of the bladder assembly. As its name implies, the OP Valve
prevents over inflation of the bladder. The valve automatically releases
air when the internal bladder pressure exceeds the valve's spring pres-
sure. The valve will automatically close when the internal bladder
pressure becomes less than the valve's spring pressure. The OP Valve
should be inspected before every dive for proper operation.
Manual Dump Valve (MD Valve)
Your OP Valve is equipped with a manual dump system to allow you to
easily dump air from the BC as you adjust your buoyancy. To manually
dump air using this system, pull the red "T" Handle down until proper
buoyancy is achieved.
Remote Exhaust Valve (RE Valve)
Your BC may be equipped with a remote exhaust valve. If it is, it is lo-
cated on the upper left, just over the shoulder, on the bladder assembly.
The RE Valve is another way to "dump" or exhaust air manually as you
adjust for neutral buoyancy. The RE Valve operates by simply pulling on
the power inflator mechanism and corrugated rubber hose.
The RE Valve should be inspected before every dive for proper op-
eration. Also, inspect that both threaded caps on the RE Valve, are
tightened securely. The exhaust cap must be tightened a minimum
1/12 turn (3/8 inch) after it first contacts the body. The RE Valve was
designed to be serviced. Without proper tightening of these caps,
they may loosen over time and be lost.
Power Inflator/ Oral Inflator Mechanism
Your Rapid-Diver BC is equipped with a power inflator/oral inflator mech-
anism. This unit consists of an Oral Valve Mouthpiece, Oral Valve Button,
and Pneumatic Inflation Valve (PIV). The PIV can operate over a pres-
sure range of 95-200 psi (6.5-13.8 bar). To inflate the BC using the PIV,
attach the low pressure hose using the quick disconnect (QD) fitting and
depress the PIV button. To inflate the BC using the oral inflator, depress
the Oral Valve Dump Button and breathe into the Oral Valve Mouthpiece.
CHECK ALL MECHANISMS BEFORE EVERY DIVE FOR
PROPER OPERATION AND LEAKS.
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

Comments to this Manuals

No comments